Official forums for BZFlag.org

hi, i made a teleporter on a mesh at 130.5 Z but when i try to go through the sending teleporter on the ground i cannot go though, i kno its because of the mesh surface blocking the teleporter but what do i do to solve it? i already tried to change the elevation by small incraments but it wont work...

Try adding inside points to your mesh.

the problem is i cannot add inside points because this teleporter leads inside the mesh not on the outside, would i add an outside point then?

you can't do that.
this should work....
make six thin walls where the outside of your box is, leaving the inside empty.

i do not see how that will help, explain

you cant put a teleporter inside a solid object.
you need to make the outer surfaces of your mesh into solid objects, leaving the interior hollow.
make a hole in your donut.

i can still go through the teleporter if i jump through thats not the problem, i left one side open on a test and it did the same exact thing, i gess i will just have to elevate it on a small box

I dont know what you are trying to do. Post the relevant bzw code if you're still having problems.